The bench rocks or wobbles
Likely cause: The floor is uneven, or the bench was moved.
- Put a spirit level on the worktop, along its length and then across its depth.
- Turn the glide under the low corner until the bubble is centred.
- Press down on each corner and adjust the glide under any corner that lifts.
A castor won't lock, or a trolley drifts
Likely cause: The castors are not locked, or swarf and debris are caught in them.
- Press each castor's brake down firmly before working.
- Clear swarf, dust and packing debris from the wheels.
- If a brake still slips, stop using the trolley and raise a request.
A drawer is out of line or hard to open
Likely cause: The drawer is overloaded, or there is debris in the slides.
- Remove some weight and spread heavy items across lower drawers.
- Clean the slides.
- Close and reopen the drawer fully to check it runs smoothly.
A shelf sits at an angle
Likely cause: The brackets are hooked at different heights.
- Clear the shelf.
- Lift it out and re-hook both ends in matching notches.
- Press down until it seats, then check it is level.
The outlet strip has no power
Likely cause: The breaker has tripped.
- Unplug the last device added.
- Reset the breaker.
- If it trips again, stop and have a qualified electrician check the supply.
Boxes stop on a flow rack
Likely cause: Debris on the rollers, or the box is too light or soft.
- Clear the rollers.
- Put soft or light items in a rigid bin.
- Load from the back and pick from the front.
Static shocks at an ESD bench
Likely cause: The mat or wrist strap is not connected.
- Check the cords from the mat and wrist strap to the 3-way connector.
- Check the grounding plug is in the facility's earth point.
- Wear the strap snug against bare skin.